Portable License for KaliBronek

Published by admin

11/12/2011 < 1 min

Facebook
YouTube
LinkedIn
Instagram
Portable License for KaliBronek is an innovative solution to not-simultaneous use KaliBronek on many computers. Instead of using expensive hardware keys (HASP) you can use a USB memory stick (PenDrive). How does it work? To create portable license you can use any USB flash drive. The license is created by using special software provided by GeoX. When you create a license, the necessary information is stored in folder “GeoX” on the removable disk. Then just install KaliBronek on any number of computers. From that moment on, you can use KaliBronek at any computer, if is connected to a computer flash drive with a license. Limitations You can not change the contents of a folder “GeoX” on the Flash Drive, or delete it, there can also be formatted pen drive. Performing any one of these activities involves the mobile license reactivation. For more information: KaliBronek page

Published by admin

11/12/2011 < 1 min

Facebook
YouTube
LinkedIn
Instagram

Tagi:

placeholder image

28/08/2023 2 min

Adjustment points in quick drawing of the grid

Click to Start Warp "with quick drawing of the grid" on the Warp tab. In...
Read more
placeholder image

28/08/2023 < 1 min

placeholder image

28/08/2023 < 1 min

TFW – problems with georeferencing files

Some versions of IntelliCAD allow the insertion of a georeferenced raster without using KaliBro. The...
Read more
placeholder image

28/08/2023 2 min

Defining adjustment points with lines

Select any drawing layer and set the desired parameters for the lines to be drawn....
Read more
placeholder image

28/08/2023 2 min

Editing of adjustment points

The editable table on the Warp tab (full view) shows all adjustment points. All loaded...
Read more
placeholder image

28/08/2023 2 min

Problems with retaining the current position ar...

On the OPTIONS tab select COMPASS SETUP. If the current position arrow or compass is...
Read more

Featured posts

placeholder image

28/08/2023 2 min

Adjustment points in quick drawing of the grid

Click to Start Warp "with quick drawing of the grid"...
Read more
placeholder image

28/08/2023 < 1 min

TFW – problems with georeferencing files

Some versions of IntelliCAD allow the insertion of a georeferenced...
Read more
placeholder image

28/08/2023 2 min

Defining adjustment points with lines

Select any drawing layer and set the desired parameters for...
Read more
0
    Your Cart
    (0)
    Your cart is emptyReturn to Shop